An item with a very high wearing rate that reduces damage in the event of an emergency.

In the case of a conventional slider due to the shape of the frame, the left and right mounting heights will differ, but the new design has been made so that they are almost the same height.

AELLA's unique taper shape makes it less likely to stick out, and the slider functions well while maintaining a clean impression.

The frame slider suppresses damage caused by unexpected falls. Since the frame of the new S1000RR is thin, if the force at the time of falling is transmitted directly to the frame, it may be damaged more than expected. Therefore, the right side adopts a new mechanism that releases the force applied during the fall. Furthermore, "heat-resistant bump rubber" is installed on both sides of the slider to avoid contact with the frame. Install the left side away from the mounting position and distribute the force at the time of the fall at the slider base. In addition, the "heat-resistant bush rubber" used in engine guards, etc., is installed so that this side does not come into direct contact with the frame.

Product specs 　　

*Compatible models
S1000RR '19-