#Suspension improvement
#Titanium
#Caliper bolt

Titanium bolt/Brembo radial mount caliper (M10×L60 P1.25)
2 bolts/1 set

Uses titanium alloy with high strength, heat resistance and corrosion resistance, lightweight (-22g per bolt)
Includes wiring holes that comply with race regulations
Laser marking process to engrave logo, size and tightening torque

The overwhelming difference from genuine bolts creates a "gap"

AELLA titanium bolts are bolts made by cutting titanium.
The seating surface is at a right angle to the bolt body with extremely high precision, and the seating surface is also wide, so the force that fastens the caliper is different than that of the genuine bolt even with the same fastening force.
As a result, AELLA titanium bolts achieve stable braking.

Compared to the genuine bolt. Naturally, the attention to "fastening" is different from that of mass-produced products.

The fastening surface of the genuine bolt is not flat, so a groove is created on the caliper side.

AELLA titanium bolts are effective on their own, but by using them in combination with titanium washers (AT-W0001), the caliper can be fastened parallel to the disc, reducing brake drag and reducing resistance that inhibits wheel rotation.

Combined use with AELLA titanium washers is even more effective.

●Compatible with
Hypermotard 698Mono

※Can also be used with other vehicle models if the size/screw pitch is the same.

A: 16.9mm B: 60mm C: 20mm Thread pitch 1.25