Titanium bolt/Brembo radial mount caliper (M10×L55 P1.25)
4 pieces/1 set
Titanium alloy with high strength, heat and corrosion resistance, weight reduction (-22g per piece)
Wiring holes compatible with race regulations
Logo, size, Tightening torque stamp
Compatible
DUCATI
Superbike Panigale V4 / 899/ 959
Monster MonsterPlus/ 1100S (’10)
Multistrada 1200DVT/ 1200/ 950
Hypermotard 1100/796/ 939
Xdiavel/ Diavel1260
Aprilia RS660
TRIUMPH
Daytona765
*Monster fits only '10 1100S other than Plus.
*Compatible with Multistrada 1200DVT - '16. ('16~ Enduro/Pikes Peak and '15~ will not fit. M10×60 mount bolt AT-DU001)
Compatibility with models other than the above are >AT-DU001 (fits most other DUCATI vehicles
AT-DU003 (some monsters, others)
.
*Please measure the bolt diameter/length before ordering.
*If the size/screw pitch is the same, it can also be used for other car models.
"Disparity" created by the overwhelming difference from the genuine bolt
AELLA titanium bolts are made by cutting titanium.
With extremely high accuracy, the bearing surface is perpendicular to the bolt body, and the bearing surface is wide, so even with the same fastening force, the force to hold the caliper is different than the genuine bolt.
As a result, AELLA titanium bolts achieve stable braking.

Comparison with genuine bolt. It's obvious, but the commitment to "fasten" is different from mass-produced products.

Because the fastening surface of the genuine bolt is not flat, A ditch has formed.
AELLA titanium bolts are effective by themselves, but
used with titanium washers (AT-W0001) By using this, the caliper can be fastened parallel to the disc, which reduces the drag of the brake and reduces the resistance that hinders the rotation of the wheel.

Use with AELLA Titanium Washer for even more effect.
#Underbody improvement
#Titanium
#Caliper bolt