Clutch cover guard (Panigale V4 / right side)

* Please be careful.
2019 The model does not fit because the installation position of the cowl is slightly different and the front of the guard comes in contact with the cowl.

Guard the magnesium crankcase securely.

Magnesium is used for pannagle V4 crankcase for weight reduction, and expensive replacement expenses are required if you get scratched on falling such as standing gobble.

The guard made by AELLA applies hard alumite treatment to aluminum scraping (A2017 material), enhancing the surface strength and color matching with magnesium cover as well as its unique color. Although it is a color like champagne gold, there is no color fading due to heat or ultraviolet rays because it is uncolored alumite. (* A slight difference in color tone arises due to the lot of alumite. It may not be exactly the same color on the left and right.)

The shape is the most obsessed place, I designed it so that thickness (pop-out) does not come out as much as possible.
The wall thickness is 6 mm at maximum and 2.5 mm at the point where no burden is imposed. Place a heat-resistant fluorocarbon rubber on the inside of the cover to relieve the shock applied to the case in the event of a fall.

○ Other merits
· Can be used with AELLA engine slider.
· Installation is possible only by removing the lower cowl, installation of the product itself is about several minutes.

Sending movies on delivery!

https://youtu.be/mRj8vIcvgBo