Special alumite (premium order)

AELLA products are anodized with the original color of your choice.

Although it is possible to make additional machining on most aluminum products, please contact us first for products other than the following. (Cannot be processed into titanium and stainless steel)

-Rear set kits
-Variable rear set kits
-Gear shift pedal
-Variable angle handle bar / separate handle
-Top bridge
-Navigation bracket
- Handle spacers
- Rear axle spacer
- Clutch cylinder
- Internal pressure control valve
- Tie down hooks etc.

■ Caution
Basically, any color of alumite will fade due to heat and ultraviolet rays. In particular, parts that are directly connected to the engine become hot and tend to fade quickly. Black anodized is harder to fade than other colors due to its thick film, but red and blue tend to fade faster than other colors due to the convenience of chemicals approved in Japan. Please understand.

The dyeing method differs depending on the material / size of the alumite, even if the same aluminum is used. Depending on the combination, there may be a difference in color. We deliver everything after inspection. Please note that we cannot accept complaints due to color differences.

■ About delivery date and time

Special color Since alumite processing requires a product in a machined aluminum base, it may take 1 to 3 months to machine the product if it is out of stock. In addition, it takes up to about 3 weeks to process alumite. When placing an order, please allow some time for the schedule.